ÍøÆغÚÁÏ

This fixed price listing is for 3 x 00457 & 2 x 00456 (5 Elements) as shown. These are the new style Pro Heat elements with the mica coating and will replace all old style elements with the exposed wires. Pro Heat elements are bonded with a heat resistant protective Mica coating, this coating must be left in place, do not try to peel it off. Because mica is a natural mineral it is not unusual for elements to have some brown blemishes or slight flaking on the mica coating, this is not a fault with the elements and does not effect the correct operation. Upon the first few uses with new elements they may glow slightly red, make a crackling noise and give off a slight smell, it is advisable to let the elements heat for a while so they settle in before using them with any products in the toaster. Approximate dimensions 140mm x 170mm. Dualit Pro Heat elements fit the Classic, Vario and Newgen range of toasters, if you have one the new LITE model toasters (Dualit's budget range) spare parts are not available as these are classed as a none-servicable appliance. The Pro Heat elements are slightly longer than the old style elements, the retaining bar that holds the element in place sits under the old style element but in the new style it sits in the V-shaped groove, see picture below to compare the two elements. The centre elements and end elements are different wattages across the range of toasters, this is because the end element only has to toast one side of the bread, the centre elements have to toast two sides, when installing the elements it does not matter which way they face, just make sure that the ends are at the end and centres in the centre. Genuine Dualit pro Heat elements are stamped on the metal rim to indicate which is the end and which is the centre element. It is important to get the correct part number for your model of toaster, a 6 slot centre element is not the same wattage as a 2 slot centre element. It is also import